Drive system |
Digital Servo Motor |
Compatible Media widths |
Min: 1.968 inches (50mm) Max: 19.055 inches (484mm) |
Maximum cutting area |
14.76 inches wide by 164.04 feet long (375mm x 50M) |
Range of guaranteed precision |
14.015 x 78.74 inches (356mm x 2M) *1 |
Carrier Sheet |
Super A3 size: 13 x 19 inches |
Maximum media thickness |
.25mm |
Maximum cutting speed (all directions) |
23.62 ips (60 cm/s) |
Maximum Acceleration (45° Angle) |
16.4 ft/sec^2 (5 m /sec^2) |
Selectable Cutting Speeds |
1–10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 cm/s |
Cutting Force (31 levels) |
20 gf to 300 gf |
Minimum Character size |
0.196 inches (5mm) for Alphanumeric characters
(varies depending on the media, font style, etc.) |
Mechanical resolution |
0.000196 inches (0.005 mm) |
Programmable resolution |
GP-GL: 254/508/1016/2540 ppi
HP-GL™ *emulation: 1016 ppi |
Repeatability precision |
0.1 mm or less per 2M *1 |
Number of Pens or Blades Mountable |
1 pen or Blade Holder at a time |
Blade Type |
Tungsten Carbide blade, 0.9mm to 1.5mm (see Accy List.)
|
Compatible Plotting Pen Type |
Water-based fiber-tip pens |
Compatible Media |
Sheet or Roll media including marking films (PVC, fluorescent, or reflective film)
up to0.25 mm in thickness. Heat and image transfer papers with backing, craft paper
with backing, card stock, polypro, kent paper, decorative media and papers with use of carrier sheet. (excluding high-intensity reflective film) |
Control Interface (selectable) |
USB 2.0 / RS-232C / Centronics Parallel |
Interface Buffer capacity |
2 MB |
Command modes (Selectable) |
GP-GL, HP-GL*2 |
Display Panel |
Liquid Crystal Display (16 characters x 1 row) |
Power Supply Rating |
100~120VAC 200~240VAC 50/60 Hz |
Power consumption |
100 VA |
Max. Operating Environment |
50° F to 95° F (10°C to 35°C) |
Recommended Environment |
60° F to 89.6° F (16°C to 32°C) |
Relative Humidity |
(35% to 75% RH non-condensing) |
External Dimensions (W x D x H) |
24.53 x 11.22 x 8.78 inches (623 x 285 x 223mm) |
Unit Weight |
20.72 Lbs (9.4 kg) |
*1: Depends on type of approved media and cutting conditions
*2: HP-GL is a registered trademark of Hewlett-Packard Company |
